http://www.thingiverse.com/thing:38160 a coin holder for my desk pic shows how close spool came to running out

http://www.thingiverse.com/thing:308335 

first try it failed will retry later

http://www.thingiverse.com/thing:26767

Go team SKYWURZ!!

This is my first attempt at casting. I followed instructions from http://3dtopo.com/lostPLA/. I did not have any PLA so I used ABS.

• I made a 50%/50% mix of sand and plaster of paris.
• I submerged the object in the mix and vacuumed it down with a shop vac and a space bag.
• I waited for about 30 min for it to cure and removed them from the cups they were in. I did this so they could dry more.
• I then baked them in the oven at about 300°F for 4 hours.
• I then put them in the furnace to burn out the ABS
• I took out the warm molds and buried in sand.

http://www.thingiverse.com/thing:23051 it does not work as well as i hoped

http://www.thingiverse.com/thing:14480 

http://www.thingiverse.com/thing:27505

http://www.thingiverse.com/thing:70427 first print with cura