Fan holder for Adapto, MendelMax and similar

t00tie's picture
Posted on: Sun, 03/31/2013 - 14:48   By: t00tie

This is a minimalistic fan holder designed for the adapto frame. It will work on any printer that uses extrusions and probably other frames too.

The tab can be hidden under the fan case for good looks or stick out for easy access to the screw holes.

Configurable scad file.

stl is for a 20mm frame and a fan with a 25mm thick case.

Heart shaped box

t00tie's picture
Posted on: Tue, 03/05/2013 - 02:48   By: t00tie

A simple geometric heart shaped box. Composed of a square and two half circles.

Use it as a jewelery box, to put a ring in or just as a toy.

The lid is flush on the inside and outside with a hidden stepped groove to keep it on.

The size is easily customised in the openscad file: all you need to specify are width, height and wall thickness.

Width is the distance from one of the flat sides to the tip of the opposite round side (eg. the width of the square that the heart would just fit inside).