Extrusion fan mount.
Fan is at 45% angle to hit stepper drivers on a Ramps controller on a MendelMax 2.0
For each installation, access to the T-Nut M5 is possible from the top through the open slot.
This is a minimalistic fan holder designed for the adapto frame. It will work on any printer that uses extrusions and probably other frames too.
The tab can be hidden under the fan case for good looks or stick out for easy access to the screw holes.
Configurable scad file.
stl is for a 20mm frame and a fan with a 25mm thick case.
mm2 power switch mount for round switch included with kit. mounts between extrusions via 2x m5 bolts/t-nut
My Taurino board holes did line up with the mounting plate plus I wanted to reach the reset button.
I could not find a printable k-cup holder that worked so i made one. i have yet to print it and will update this once i have.
A simple geometric heart shaped box. Composed of a square and two half circles.
Use it as a jewelery box, to put a ring in or just as a toy.
The lid is flush on the inside and outside with a hidden stepped groove to keep it on.
The size is easily customised in the openscad file: all you need to specify are width, height and wall thickness.
Width is the distance from one of the flat sides to the tip of the opposite round side (eg. the width of the square that the heart would just fit inside).
Modified from thingiverse.com/thing:28735 for cooling a dual QU-BD on a MM2 i have redesigned this to work better